{"id":4367,"date":"2019-06-20T15:39:28","date_gmt":"2019-06-20T15:39:28","guid":{"rendered":"https:\/\/charcoalmachines.com\/?p=4367"},"modified":"2024-03-29T16:26:10","modified_gmt":"2024-03-29T08:26:10","slug":"how-to-make-charcoal-with-the-airflow-hoisting-carbonization-furnace-step-by-step","status":"publish","type":"info","link":"https:\/\/charcoalmachines.com\/fr\/how-to-make-charcoal-with-the-airflow-hoisting-carbonization-furnace-step-by-step\/","title":{"rendered":"Comment fabriquer du charbon de bois avec le four \u00e0 carbonisation par soufflage d'air \u00e9tape par \u00e9tape ?"},"content":{"rendered":"

The airflow hoisting carbonization furnace is composed of the movable outer stove, inner stove, airflow pipes, ignition port, hoisting equipment, and the flue gas purification equipment<\/b><\/strong><\/a>. The inner stove is independent so that the charcoal furnace can be a single inner stove, three inner stoves, and four inner stoves. The carbonization inner stoves are connected by pipes, and the combustible gas in the carbonization process<\/b><\/strong> can burn each inner furnace which has high working efficiency and can save fuel consumption.<\/p>\n\n\n\n

\"Four
Four \u00e0 carbonisation par soufflage d'air 1<\/figcaption><\/figure>\n\n\n\n

Les d\u00e9tails du processus de fabrication du charbon de bois par le <\/b><\/strong>four de carbonisation \u00e0 levage d'air<\/b><\/strong>:<\/b><\/strong><\/h2>\n\n\n\n

\u00c9tape 1 : processus de s\u00e9chage<\/h3>\n\n\n\n

After placing the inner stove which is of the biomass rods in the charbon <\/b><\/strong>furnace<\/b><\/strong>, to ignite at the ignition port below the furnace, and the temperature in the furnace is gradually heated from normal temperature to about 100 \u00b0C. Because the temperature inside the furnace before ignition is low, this process should be heated with a large fire, reaching 100 degrees to the left, and then use a small fire to heat the carbonization<\/b><\/strong> temperature<\/b><\/strong> to 170 \u00b0 C – 200 \u00b0 C or so.<\/p>\n\n\n\n

\u00c9tape 2 : processus de pyrolyse<\/h3>\n\n\n\n

When the temperature in the carbonization furnace reaches 170 \u00b0 C – 200 \u00b0 C, use a simmer to heat the furnace temperature to about 340 \u00b0 C. The second phase takes about 2 hours and 30 minutes.<\/p>\n\n\n\n

\"four
four \u00e0 carbonisation par soufflage d'air 2<\/figcaption><\/figure>\n\n\n\n

\u00c9tape 3 : processus de pyrolyse rapide<\/h3>\n\n\n\n

When the temperature in the furnace reaches about 340 \u00b0C, use a small fire to heat the furnace temperature<\/b><\/strong><\/a> from 340 \u00b0C to 380 \u00b0C – 400 \u00b0C. The third phase takes about 2 hours.<\/p>\n\n\n\n

\u00c9tape 4 : fin de la carbonisation<\/h3>\n\n\n\n

Lorsque la temp\u00e9rature dans le four atteint environ 400 \u00b0C, il n'y a plus de changement de temp\u00e9rature significatif par la suite. Utilisez un petit feu pour chauffer, lorsque la fum\u00e9e sortant du conduit de fum\u00e9e est consid\u00e9rablement r\u00e9duite et \u00e9claircie, \u00e9teignez la flamme et la carbonisation est termin\u00e9e. La quatri\u00e8me phase dure environ 40 minutes.<\/p>\n\n\n\n

\u00c9tape 5 : refroidissement et d\u00e9chargement du charbon de bois<\/h3>\n\n\n\n
\n\n<\/figure>\n\n\n\n

After the carbonization is completed, if no other cooling measures are taken, the fire can be sealed and the charcoal can be naturally cooled. There are two ways to seal fires: Method 1: seal the smoke outlet and cool the charcoal, and the surface of the Briquettes de charbon<\/b><\/strong><\/a> is good. This method takes about 16 hours to cool down the charcoal. Method 2: completely open the smoke outlet and cool the charcoal. This process is the same as method 1, but the charcoal surface is not shiny like the former. This method takes about 16 hours for cooling. In these two ways, when the temperature in the furnace drops to about 40\u00b0C, to discharge the charcoal is ideal.<\/p>\n\n\n\n

\u00c9quipement de production de charbon de bois \u00e0 vendre<\/strong><\/h2>\n\n\n\n
\"briquettes
briquettes de charbon de bois1<\/figcaption><\/figure>\n\n\n\n

Note: If there is no temperature measuring device or temperature measuring device damaged in the four de carbonisation \u00e0 levage d'air<\/a><\/b><\/strong>, the small-fire firing in the carbonization process shall take 7-8 hours. It is strictly forbidden to use a large fire during the carbonization process. At the end of carbonization, when the amount of smoke from the outlet is significantly reduced and the smoke is light, the flame should be extinguished and the carbonization is over.<\/p>","protected":false},"excerpt":{"rendered":"

The airflow hoisting carbonization furnace is composed of the movable outer stove, inner stove, airflow pipes, ignition port, hoisting equipment, and the flue gas purification equipment. The inner stove is independent so that the charcoal furnace can be a single inner stove, three inner stoves, and four inner stoves. The carbonization inner stoves are connected […]<\/p>\n","protected":false},"author":1,"featured_media":4369,"parent":0,"comment_status":"open","ping_status":"open","template":"","meta":{"wpai_generated_summary":""},"tags":[23,6,52],"info-type":[2],"class_list":["post-4367","info","type-info","status-publish","has-post-thumbnail","hentry","tag-carbonization-furnace","tag-charcoal-machine","tag-charcoal-making-machine","info-type-faq"],"_links":{"self":[{"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/info\/4367","targetHints":{"allow":["GET"]}}],"collection":[{"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/info"}],"about":[{"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/types\/info"}],"author":[{"embeddable":true,"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/users\/1"}],"replies":[{"embeddable":true,"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/comments?post=4367"}],"wp:featuredmedia":[{"embeddable":true,"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/media\/4369"}],"wp:attachment":[{"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/media?parent=4367"}],"wp:term":[{"taxonomy":"post_tag","embeddable":true,"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/tags?post=4367"},{"taxonomy":"info-type","embeddable":true,"href":"https:\/\/charcoalmachines.com\/fr\/wp-json\/wp\/v2\/info-type?post=4367"}],"curies":[{"name":"wp","href":"https:\/\/api.w.org\/{rel}","templated":true}]}}