如何一步步用气流升降炭化炉制作木炭？

The airflow hoisting carbonization furnace is composed of the movable outer stove, inner stove, airflow pipes, ignition port, hoisting equipment, and the flue gas purification equipment. The inner stove is independent so that the charcoal furnace can be a single inner stove, three inner stoves, and four inner stoves. The carbonization inner stoves are connected by pipes, and the combustible gas in the carbonization process can burn each inner furnace which has high working efficiency and can save fuel consumption.

通过该过程制造木炭的详细步骤 气流提升碳化炉:

第1阶段：干燥过程

After placing the inner stove which is of the biomass rods in the 炭 furnace, to ignite at the ignition port below the furnace, and the temperature in the furnace is gradually heated from normal temperature to about 100 °C. Because the temperature inside the furnace before ignition is low, this process should be heated with a large fire, reaching 100 degrees to the left, and then use a small fire to heat the carbonization temperature to 170 ° C – 200 ° C or so.

第2阶段：热解过程

当炭化炉内温度达到170°C-200°C时，用小火将炉温加热至约340°C。第二阶段大约需要2小时30分钟。

第3阶段：快速热解过程

When the temperature in the furnace reaches about 340 °C, use a small fire to heat the furnace temperature from 340 °C to 380 °C – 400 °C. The third phase takes about 2 hours.

第4阶段：碳化结束

当炉内温度达到约400°C后，温度不再明显变化。用小火加热，当烟道排出的烟明显减少且变轻时，熄灭火焰，炭化结束。第四阶段大约需要40分钟。

第5阶段：木炭冷却和排放过程

After the carbonization is completed, if no other cooling measures are taken, the fire can be sealed and the charcoal can be naturally cooled. There are two ways to seal fires: Method 1: seal the smoke outlet and cool the charcoal, and the surface of the 木炭压块 is good. This method takes about 16 hours to cool down the charcoal. Method 2: completely open the smoke outlet and cool the charcoal. This process is the same as method 1, but the charcoal surface is not shiny like the former. This method takes about 16 hours for cooling. In these two ways, when the temperature in the furnace drops to about 40°C, to discharge the charcoal is ideal.

出售木炭生产设备

Note: If there is no temperature measuring device or temperature measuring device damaged in the 气流提升碳化炉, the small-fire firing in the carbonization process shall take 7-8 hours. It is strictly forbidden to use a large fire during the carbonization process. At the end of carbonization, when the amount of smoke from the outlet is significantly reduced and the smoke is light, the flame should be extinguished and the carbonization is over.